Metrohm 856 Conductivity Module - Manual (Page 17)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
856 Conductivity Module
￭￭￭￭￭￭￭￭ 9
3.2.1.1 Connecting a Touch Control
NOTE
The plug is protected against accidental disconnection of the cable by
means of a pull-out protection feature. If you wish to pull out the plug,
you will first need to pull back the outer plug sleeve marked with
arrows.
Connect the Touch Control as follows:
1 ￭ Insert the plug of the Touch Control connection cable into the
Controller socket.
Figure 4 Connecting the Touch Control
2 ￭ Connect the MSB devices (see Chapter 3.3, page 12).
￭ Connect the USB devices (see Chapter 3.4, page 16).
3 ￭ Connect the Conductivity Module to the power supply.
4 ￭ Switch on the Touch Control.
The Touch Control power supply is supplied through the Conductivity
Module. Automatic system tests are performed on both instruments
at the time of activation. The On LED on the front of the Conductiv-
ity Module lights up when the system test has been completed and
the instrument is ready for operation.