Metrohm 940 Professional IC Vario ONE/SeS/PP/Prep 3 - Manual (Page 62)

3.19 Connecting the instrument to a computer
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
52 ￭￭￭￭￭￭￭￭
940 Professional IC Vario ONE/SeS/PP/Prep 3 (2.940.1530)
4 Connecting the rinsing solution output capillary
￭ Fasten the capillary labeled waste rins. to the waste collector. You
can find information on installing the waste collector in the leaflet
accompanying the IC equipment: waste collector (6.5336.000).
￭ Alternative: Direct the capillary labeled waste rins. into a suffi-
ciently sized waste container and fasten it in place there.
5 Connecting the regeneration solution input capillary
￭ Fasten the capillary labeled regenerant to the pump tubing con-
nection carrying the regeneration solution using a short pressure
screw (6.2744.070).
6 Connecting the regeneration solution output capillary
￭ Fasten the capillary labeled waste reg. to the waste collector
(6.5336.000). You can find information on installing the waste
collector in the leaflet accompanying the IC equipment: waste
collector (6.5336.000).
￭ Alternative: Direct the capillary labeled waste reg. into a suffi-
ciently sized waste container and fasten it in place there.
3.19 Connecting the instrument to a computer
NOTE
The instrument must be switched off when being connected to a com-
puter.
Accessories For this step you need the following accessories:
￭ USB connecting cable (6.2151.020)