Beko AUTOMATIC WASHING MACHINE WM 7335 W - Manual (Page 22)

EN 22
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the “On/Off” button.
2. Select the programme and the
temperature.
3. If required:
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press “Start/Pause/Cancel”
button. The display shows the
time remaining for the program to
complete if time delay is not set.
6. Check if the program follow-up
indicator on the screen lights up.
Canceling a program
1. Press and hold the `Start/Pause/
Cancel` button for about 3 seconds;
the “Ready” light will start flashing.
2. The machine can drain all the water
or can take in water for 3 times at
most to cool down the clothes and
complete draining process.
Adding more laundry
• This is only possible under the
following conditions:
1. during time delay,
C You may add or remove laundry
during the time delay (until the
program starts).
2. At the beginning of a washing cycle,
C Machine allows adding more laundry
during a future step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low
In order to add laundry after the start-up
of the program:
1. Press “Start/Pause/Cancel”
button. Wait for the safety lock to
open. "Ready" lamp will light up
continuously.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press “Start/Pause/Cancel” button.
Program is in rinse hold mode
C This process is shown with the
flashing " " symbol.
If you wish to spin when the machine is
in this mode:
1. Adjust the spin speed.
2. Press “Start/Pause/Cancel” button.
Program resumes. Your machine
drains the water and spins your
laundry.
If you want to drain the water without
spinning:
Press “Start/Pause/Cancel” button. The
program continues and only drains the
water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in machine.
2. Select the spin program.
3. Adjust the spin speed.
After the program is finished
Program indicator lights on the screen
remain lighted up after the program is
finished.
1. “End” will appear on the screen
when “ready” lamp lights up in the
program follow-up indicator. Open
the loading door and remove the
laundry.
2. Press the “On/Off” button.
3. Turn off the water tap.
4. Eliminate any folding of the rubber
seal on the loading door and check
for impurities.
5. Leave the loading door and
detergent drawer open to dry.
6 Quick instructions for daily use