Beko AUTOMATIC WASHING MACHINE WM 7335 W - Manual (Page 26)

EN 26
Cause Explanation / Suggestion
Programme cannot be started or selected.
Machine may have switched to self
protection mode due to an infrastructure
problem (such as line voltage, water
pressure, etc.).
Bring your machine to factory settings by turning the
programme selection knob. (see, Ending the programme
through canceling)
Water in the machine.
There may be some water in your machine
when you receive it. This is from the quality
control process and is normal.
It is not harmful to your machine.
There is water coming from the bottom of the machine.
There might be problems with hoses or the
pump filter.
- Make sure that the seals of the water inlet hoses are
securely fitted.
- Tightly attach the drain hose to the tap.
- Make sure that the pump filter is completely closed.
Machine does not fill with water
- Tap may be turned off.
- Water inlet hose might be bent.
- Water inlet filter might be clogged.
- The loading door may be ajar.
- Open the inlet water taps fully.
- Flatten the water intake hose.
- Clean the water intake filter.
- Close the loading door.
Machine does not discharge water.
- Water outlet hose might be clogged or
twisted.
- Pump filter may be clogged.
- Clean or flatten the hose.
- Clean the pump filter.
Machine vibrates or shakes.
- Machine feet might not be adjusted.
- Transportation safety bolts might have not
been removed.
- There may be a small amount of laundry in
the machine.
- The machine may be overloaded or the
clothes may be distributed unevenly.
- There machine might be touching a solid
surface.
- Adjust the machine feet.
- Remove the transportation safety bolts.
- Add more laundry to the machine.
- Reduce the amount of laundry in the machine or
balance the load by hand.
- Ensure that nothing touches the machine.
Machine stops shortly after the programme starts.
Machine can stop temporarily due to low
voltage.
It will resume operating when the voltage is back to the
normal level.
The water being taken in is directly discharged.
Improper position of the drain hose.
Connect the water draining hose as described in the
operation manual.
No water can be seen in the machine during washing.
This is not a problem. The water level is not
visible from the outside of the machine.
8 Solution suggestions for problems