Bissell 1620 - Manual (Page 8)

8
When It’s Time To Empty The Tank-in-Tank
NOTE: Remove the Tank-in-Tank, following steps 1
and 2 on page 7.
Carry the Tank-in-Tank, like a bucket, to the sink to dispose
of the dirty water. Remove Tank Lid. Pour out dirty water.
After each use, remove and rinse the red Lint Screen
located on the Tank Lid.
Remove Tank Lid.
Remove Lint Screen and rinse under faucet.
Remove any debris caught in Lint Screen.
Reinsert Lint Screen on Tank Lid. The screen will
click into place.
Replace Tank Lid.
Refill with clean hot tap water—follow steps 4-5 on
page 7.
When the cleaning job is complete, rinse out the Tank-in-
Tank by running clean water between the bladder and
the tank.
Return the Tank-in-Tank to the machine, following step 5 on
page 7.
Refer to the Maintenance/Storage section on pages 12-13
for final cleanup.
The Flow Indicator is located on the machine base. It spins when
the trigger is pressed to indicate the machine is applying cleaning
solution to the floor. It will stop spinning to indicate the SmartMix
Bottle or bladder needs to be refilled, or when the trigger is
released. The Flow Indicator does not spin when the ReadyTools
Dial is set to TOOLS/PRETREAT.
The ReadyTools Dial regulates suction for floor or upholstery cleaning
with the turn of a dial. For carpet/floor cleaning make sure the dial is
set to FLOOR CLEANING. For upholstery or fabric cleaning, attach
Tough Stain Tool to the the Flex Hose, switch to TOOLS/PRETREAT
and the PowerLifter Plus is ready to clean upholstery,
fabrics and more.
1.
2.
A.
4.
3.
5.
B.
C.
D.
Lint Screen
Latched
1
2
5
6.
The Flow Indicator
ReadyTools ™ Dial
Flow Indicator
TOO LS
PRETR EAT
FLO OR CLEAN ING
ReadyTools Dial
A special red float device in the
tank lid will cause the cleaner to
stop removing solution from the
carpet. The motor sound will rise
in pitch to let you know the dirty
water tank is full.
Tip: