BT Freestyle 130 - Manual (Page 23)

Freestyle 90/130/1200 Additional Handsets
21
To erase a registration code
• Press the QUICKDIAL button.
• Press the CHANNEL SEEKER
button.
• Press the ✱ button four times.
• Press the QUICKDIAL button.
You will hear a confirmation
beep, the old registration code is
now erased and you can re-
register your additional handset
following the procedure above.
To re-register an additional
handset
If necessary you can re-register
your additional handset by simply
following the steps described in ‘To
register an additional handset’on
the previous page.
Before re-registering the old
registration code must first be erased.
To check that your additional
handset is registered correctly
• Lift the additional handset.
• Press the TALK button.
• Listen for the dial tone.
If you do not hear a dial tone, your
additional handset is either out of
range of your Freestyle 130, the
Freestyle 130 phone line cord is not
plugged in, it has not been
registered properly or you may
have purchased the wrong
handset - check that the handset
you have is item code: 871267.
This can be found on the side of
your giftbox.
Setting the handset
number
Each additional handset must be
assigned an identity number (1, 2, 3
or 4). Your Freestyle 130 handset is
already numbered as
HANDSET 1 ,
additional handsets can then be
numbered as they are added.
To set a handset identity number
• Press and release the
QUICKDIAL button.
• Press and release the SECRECY
button.
• Enter the identification number
(1-4) using the keypad.
• When you have entered the
number press the
QUICKDIAL
button.
• You will hear a beep confirming
that the new number has been
stored.
Your Freestyle additional handset is
pre-set to handset number 2.
Make a note of the identification
number by writing it on the handset’s
directory label.