BT Freestyle 130 - Manual (Page 9)

Setting up
7
Warnings
1 Do not try to use any power supply
other than the one provided. This
may permanently damage your
Freestyle 130.
2 Your Freestyle 130 should not be
fitted in wet or damp conditions, for
example in a bathroom. Also, the
handset should not be left out in
the rain.
3 There is a slight chance that your
phone could be damaged by an
electrical storm. We recommend
that you unplug the base unit from
the mains during storms.
4 Plug the power cable
into the back of the base
unit
Plug the adaptor cable into the
socket on the back of your
Freestyle 130.
PHONE LINE
12V AC
5 Connect the base unit
three-pin adaptor to a
power socket
When the power is switched on at
the mains, the red
POWER light on
the base unit will light up.
POWER
6 Charge the handset
When you first use your Freestyle
130, the rechargeable battery in the
handset needs charging for 24 hours.
• Make sure you have connected
your Freestyle 130 to the mains
power supply; see steps 4 and 5.
• Place the handset on the base
unit, ensuring the contacts are
touching. The red
CHARGING light
comes on.
• The CHARGING light remains
on while the handset is on the
base unit.
• When sufficiently charged for use,
the
CHARGING light turns green.
Mains power adaptor
The Freestyle 130 must only be used
with the adaptor supplied.
Using any other adaptor will result in
non-compliance with EN60950:1992,
and will invalidate the approval given
to this apparatus.