Check list before using the dryer, Preparing to transport the dryer ć step by step – Bosch WTMC6321US User Manual

Page 9

Advertising
background image

9

The dryer should be level with all

four feet firmly on the ground. The

dryer must not wobble. If the dryer

is not level or if it does wobble, the

feet must be adjusted. Adjust the

heightĆadjustable feet until the

dryer does not rock and is level,

both frontĆtoĆback and

sideĆtoĆside.

11. Connect the exhaust duct to the

exhaust air outlet on the dryer.

12. Insert plug into the wall receptacle.

Check list before using

the dryer

1. Check that steps 1Ć12 have been

implemented properly.

2. Ensure that the dryer is connected

to the power supply.

3. Read the operating instructions to

understand how your dryer

operates.

4. Conduct an appliance test:

q Check that the drum is empty.
q Close the dryer door.
q Switch the dryer to Extra Dry"

and then press the Start

button.

q After 3Ć5 minutes press the

Stop button and open the door.

5. If the interior of the dryer feels

warm, the dryer has been

connected properly.

Switch the dryer to OFF".

6. If the dryer does not work, switch

the dryer to OFF".

Look in the troubleshooting

section (page 21) of the

OPERATING INSTRUCTIONS and

find the fault.

Preparing to transport the

dryer ć step by step

1. Rotate the program selector

to OFF".

2. Pull out power supply plug.

3. Disconnect the exhaust duct from

the exhaust air outlet on the dryer.

4. Place any accessories in the drum.

5. Close the door and secure with

adhesive tape.

6. Screw the heightĆadjustable feet of

the dryer into the housing to

prevent them from being damaged

during transportation.

Advertising
This manual is related to the following products: