JK Audio innkeeper 4 - Manual (Page 10)

10
Operation - Menu Display (continued)
Call History View (2,1) Allows you to view name and phone num-
bers of automatically added entries. You may dial the selected entry
from this menu by simply pressing the Call button on any phone line.
Call History Clear (2,2) Press Enter from this menu to clear all auto-
matically added history entries. You will be prompted to confirm your
intent to clear the entire call history before deletion.
Config. (3) This menu allows you to control Auto-Answer, Auto-
Disconnect, Audio Levels, Master Send, Calibration, Conferencing
and Restore Factory Default or Custom Settings.
Config. Auto-Answer (3,1) Here you can configure Auto-Answer.
Config. Auto-Answer On/Off (3,1,1) This menu allows you to turn
Auto-Answer on and off for each line independently or for all lines.
Config. Auto-Answer Ring Count (3,1,2) Select the number of rings
before the unit auto-answers on each line individually or on all lines.
Config. Audio Levels (3,2) Audio levels for each phone line input
and output can be set here. The Audio Levels menu allows you to
adjust audio in 1 dB increments over a ±10 dB range. You may adjust
the levels of the Send inputs as well as the Caller outputs.
Config. Audio Levels Send (3,2,1) Send input levels can be set for
each line individually or all lines. These settings affect the independ-
ent Send input as well as the Master Send for the selected line(s).
Config. Audio Levels Caller (3,2,2) Caller output levels can be set
here for each line independently or all lines.
Config. Master Send (3,3) This menu gives you the ability to turn the
Master Send on or off for each line individually or all phone lines.
Config. Calibration (3,4) Here you can send a 1kHz test tone down
the phone line(s) and the output jacks. You may turn the tone on or
off for each line individually or for all lines. This is not required for set-
ting the null. This tone is only for your convenience in setting your
equipment audio levels.
11
Operation - Menu Display (continued)
Conference (3,5) innkeeper 2 only. This menu allows you to config-
ure settings for the Conference feature. See pages 14-15.
Conf. Send Mix Mode (3,5,1) innkeeper 2 only. Configure the Send
Mix Mode to "Send Mix" default or "No Mix". The "Send Mix" default
option mixes both the Line 1 Send and Line 2 Send audio signals to-
gether and sends that audio down both phone lines. The "No Mix"
option does not mix these signals together. Line 1 Send audio will
only go to Phone Line 1 and Line 2 Send audio will only go to Line 2.
You may still use the Master Send input to send a common audio sig-
nal to both phone lines.
Conf. Caller Mix Mode (3,5,2) innkeeper 2 only. Configure the Caller
Mix Mode to "No Mix" default, "Caller Mix" or "Full Mix Minus". The
"No Mix" option does not mix any audio together on the Caller output
jacks. Caller 1 out will contain Line 1 Caller audio and Caller 2 out will
contain Line 2 Caller audio. The "Caller Mix" option mixes together
both caller audio signals on both Caller output jacks. Caller 1 and
Caller 2 outputs will contain both Line 1 and Line 2 caller audio. The
"Full Mix Minus" option provides a mix-minus signal output on both
Caller output jacks. Caller 1 out will contain Line 1 caller audio, Line 2
caller audio and Send 2 audio. Caller 2 out will contain Line 1 caller
audio, Line 2 caller audio and Send 1 audio.
Config. Presets (3,6) With this menu you can save and restore cus-
tom presets or reset the unit to factory default presets.
Config. Presets - Default (3,6,1) Here you may restore factory de-
fault presets. You will be prompted to confirm Factory Reset after se-
lecting this option.
Config. Presets - Custom (3,6,2) Here you may save and restore
custom presets based upon your current configuration.