Kino Flo BarFly 200D - Manual (Page 9)

9
Remote Dimmer Operation
The Remote Dimmer (DIM-5) is designed to remotely dim the BarFly.
A 15ft dimming cable is supplied with the dimmer.
Insert the dimmer cable into the receptacle marked
REMOTE DIM.
Inserting the dimmer cable will automatically
disable the onboard dimmer.
Insert the other end of the dimmer cable into the
Remote Dimmer (DIM-5).
Dimming Control
Dimming and Color Temperature Shift
Dimming can be used to adjust the light output of the fixture. The color temperature
will shift marginally if kept to within one f-stop. Dimming beyond one f-stop may result
in a reduction of color temperature as well as a noticeable shift to magenta.
Manual Dimming Control
The BarFly 200D features a built-in dimmer control.
For full light output, turn dimmer fully clockwise.
An input jack for an optional Remote Dimmer (DIM-5)
is located next to the manual dimming knob.
Note: The ballast is designed to start lamps at any
dim setting. However, in cold temperatures, if the
ballast does not start, turn off the ballast. Make sure
the dimmer is set to full and restrike. Once the lamps
have come up to full temperature after a few minutes,
then dim to the desired light level.