Kino Flo Select Single(115, 105) - Manual (Page 6)

6
Inserting Lamps
Gelling the Fixture
Locking Lamp Connector:
Depress both tabs on lamp connector and apply to lamp pins.
Match the Harness color-codes at each end of the lamp.
Push lamps into the fixture’s Lamp Holder Clips.
Restricting the airflow around the lamps can cause the lamps to
operate hotter. This increased heat will raise the lamp’s color
temperature and green spike. Therefore, it is recommended to
clip gels to the doors of the fixture.
Do Not clip gels to louver.
Do Not block the fixture ends in a manner that restricts airflow.