Kino Flo Select Single(115, 105) - Manual (Page 9)

9
The Ballast operates remote from the fixture. Connect the Extension cable to the
Ballast and the Lamp Harness. After the lamps are properly installed, the Ballast can
be turned on. Each switch controls one lamp. The color bands on the lamp harness
correspond to the switches as illustrated.
Lamp Select Feature
The Select Ballasts have a 4ft/2ft switch. Set the selector switch to 4ft for 4ft lamps
and 2ft for 2ft lamps.
When operating 4ft lamps in high ambient temperature or where the units are rigged
into place with restricted airflow, the 2ft setting can be used to lower the color tempera-
ture and remove any green spike. The light drops about a half an f-stop in exposure
when dropping from 4ft to 2ft.
It is not recommended to operate 2ft lamps in the 4ft setting. At the 4ft setting, the
color temperature of the 2ft lamps will rise dramatically and experience a high green
spike.
Extension Cable
To insert the cable, position the logo up to align the key ways
on the extension cable with the circular receptacle on the
ballast. Rotate the locking ring until it clicks into the lock
position.
Lamps can operate as far as 75 feet from the ballast.
(3 x 25ft extensions)
A Splitter can be used at the Ballast or on the end of an
Extension Cable to split a 4Bank run into either four Singles or
two Doubles. This allows for greater rigging flexibility.
A Combiner can connect a number of smaller ballasts to a
larger fixture. For example, four Single Ballasts or two Double
Ballasts can be combined to a 4Bank Extension or Fixture.
Red
Yellow
Black
Blue