Casablanca Fan Company Inteli-Touch 3 PN - Manual (Page 7)

7
B
el
A
ir
®
BLADE SCREW
(4 PER BLADE)
FLAT WASHER
(4 PER BLADE)
Step 13. Screw the 100 Watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is extremely
important that the glass be clean. If it is touched, or dirty,
clean carefully with a tissue. A dirty glass bulb will cause the
bulb to fail almost immediately.
Step 12. blade Installation
Attach the blades to the
blade holders with four blade
screws and four steel washers
provided for each blade.
Hand tighten securely.
Step 14. Position the indentations in the outer rim of the glass
shade so that they line up with the tabs on the inside surface
of the fan light fixture rim.
Step 15. Carefully lift the glass shade up inside the light fixture
as far as it will go.
Step 16. Rotate the shade in a clockwise direction until it is
held tightly in place by the three tabs.
LIGHT
FIXTURE
TABS
GLASS
SHADE
GLASS SHADE
INDENTATION
iMPortaNt! When installing the halogen bulb,
carefully cut off the end of the plastic sleeve the bulb
comes in and hold the bulb by the plastic sleeve to
screw it into the socket.
BLADE SCREW (4
PER BLADE)
FLAT WASHER
(4 PER BLADE)
HALOGEN BULB
100 WATT
TIP: At first the shade is a very loose fit in the
fixture and can be ‘wiggled’ a little from side to
side. It is a great help when rotating the glass shade
to ‘wiggle’ it at the same time.
INSTALLING THE GLASS SHADE
INSTALLING THE HALOGEN BULB
CENTER STYLE BLADE HOLDER & BLADE
BLADE HOLDER HARDWARE