Casablanca Fan Company Inteli-Touch 3 PN - Manual (Page 8)

® 3
8
WALL CONTROL AND HARDWARE (not to scale)
Switch Mounting
Screws (2)
Wall Plate
Screws
(2) White
(2) Almond
White Wall
Plate(1)
W-85
Wall Control
Switch Bezels
(1) White
(1) Almond
Almond Wall
Plate(1)
(4) Wire Cap
Before installing the W-85 wall control you will need to
check and see if you will need to change the bezel on
the front of the wall control from WHITE to ALMOND.
If you are going to use white, skip these steps and go
to wall control installation starting on page 1. The
bezel can be changed at any time before or after
installation. The wall control does not need to be
uninstalled to replace the bezel.
W-85 Wall Control Bezel Replacement installation
as follows
Step 17a. Locate the four (4) tabs holding the bezel to
the front of the switch, then press in on each tab one
at a time, removing the bezel as shown in Figure #1.
Step 17b. Locate the rubber key pad attached to
the four (4) locating pins as shown in Figure #2 and
remove rubber key pad from the WHITE bezel, also
as shown in Figure #2.
WARNING!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAUTION! NOT turning the power OFF at the
circuit breaker or fuse box may cause damage to
the electronics within the wall control and or the PC
board on the fan.
Figure #2
WHITE
BEZEL
RUBBER KEY
PAD
LOCATING
PINS (4)
LOCATING
PINS
HOLES(4)
W-85 CONTROL INSTALLATION
Figure #1
BEZEL
BEZEL
TABS