Rite-Ride 4190 - Manual

07-13
READ INSTALLATION INSTRUCTIONS COMPLETELY BEFORE INSTALLING YOUR KIT
INSTALLATION INSTRUCTIONS
Congratulations—your new suspension helpers are
quality products capable of improving the handling and
comfort of your vehicle while under load. As with all
products, proper installation is the key to obtaining all of
the benefits your kit is capable of delivering. Please take
a few minutes to read through the instructions to identify
the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your
kit with the parts list below.
NOTE: IF ANY PARTS ARE MISSING FROM THE KIT,
PLEASE CALL 1-800-888-0650.
PLEASE DO NOT CALL OR RETURN THE KIT TO
THE DEALER.
Be sure to take all applicable safety precautions during
the installation of the kit. The instructions listed in this
brochure and the illustrations all show the left, or driver’s
side of the vehicle. To install the right side assembly
simply follow the same procedures.
VEHICLE PREPARATION
With the vehicle on a solid level surface, chock the front
wheels and raise the vehicle using a jack rated for your
vehicle’s weight. Lift the wheels off the ground. Lower
the vehicle frame onto jack stands rated for your vehicles
WARNING
Do not inflate this assembly when it is
unrestricted. The assembly must be restricted
by a coil spring. Do not ever inflate beyond
recommended operating pressures for your
specific vehicle. Improper use or over inflation
may cause property damage or severe personal
injury.
weight making sure the suspension is fully extended. (Do
NOT use wood or concrete blocks to support the weight of
the vehicle.) Remove the jounce bumpers located under
the frame rail, by prying them out of the jounce bumper
cup. The jounce bumpers will not be re-used with this kit
but the bolts will be reused.
SHOCK ABSORBERS
If necessary, additional clearance between the coil turns
may be obtained by removing the shock absorbers from
the lower shock mounts and lowering the suspension
an additional one to two inches. (CAUTION: Do not put
strain or tension on the flexible brake line.)
4190
PARTS LIST
COIL-RITE AIR SPRING 6130 2
WORK-RITE BUMPER 1258 2
COIL-RITE SUPPORT 0045 2
FACE PLATE 5784 2
SPACER RING 5786 2
CLAMP RING 5785 4
1/2" SPACER 0013 2
1/4" SPACER 5229 2
AIR LINE 0007 1
STRAIGHT FITTING 3439 2
BOLT PACK
3/8"-16 X 1" HEX BOLT 2
3/8"-16 X 2" HEX BOLT 2
3/8"-16 X 1-1/2" FLAT HEAD BOLT 12
3/8"-16 FLANGE LOCK NUT 14
3/8" WASHERS 2
5/16" WASHERS 4
INFLATION VALVE 3098 2
VALVE CAP 3099 2
NYLON TIES 9168 6
THERMAL SLEEVE 0899 2
www.riderite.com
OPERATING PRESSURES:
MINIMUM (UNLOADED) 5 PSI
MAX (LOADED) 35 PSI