Cal Flame 3000 - Manual (Page 12)

Owner’s Manual Drop-In Grills
Page 11 Owner’s Manual
Rotis Spit Handle
Rotis Spit Bracket
Rotis Spit Bushing
Rotis Spit Fork
Rotis Spit Rod
Rotis Motor Bracket
Rotis Motor
Figure 3. Rotisserie Burner Assembly
Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push and hold the rotisserie burner knob in for about 5 seconds to allow gas into the the infrared burner, then
rotate knob rapidly counter clockwise past the light position (You will hear a loud click).
3. If the burner does not light on the first try, repeat immediately.
4. If the burner does not light within 5 seconds, turn the control knob to the OFF position. Wait 5 minutes until
the gas clears before attempting to light it again.
5. Repeat the procedure or try "Manual Lighting procedure" as shown below.
6. Upon successful lighting, repeat the process on any other available IR burner you may wish to light.
Manually Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push and hold the rotisserie burner knob in for about 5 seconds to allow gas into the the infrared burner, then
rotate knob rapidly counter clockwise past the light position (You will hear a loud click).
3. Hold a lit long stem match next to the burner ports.
4. If the burner does not light within 5 seconds, turn the control knob to the OFF position. Wait 5 minutes until
the gas clears before attempting to light it again.
5. If the burner does not light after several attempts see troubleshooting located in the back of this manual.
6. Upon successful lighting, repeat the process on any other available IR burner you may wish to light.
Off
Light
High
Low
Figure 4. Rotisserie Burner Knob.