Cal Flame 3000 - Manual (Page 49)

Owner’s Manual Cal Flame Entertainment System
Owner’s Manual Page 48
Remote Control Operation (Figure 44)
1. TV Controls:
a. TV Power
Press this button to turn on the set.
Press the button again to turn the set off.
2. Direct Access (0-9, 1--) Number Buttons
Use these buttons to select a channel. The channel number chosen will be displayed on the screen for about
four seconds. To select channels 0-99, press two numbers. For example, to select channel 8, press 0,8. To
select above 100, press the 1-button, then the number buttons for the last two digits of the channel. For
example, to select channel 115, press 1--, 1,5.
3. CHANNEL Up and Down
Use these buttons to select pre-programmed channels of two select channels up or down.
4. VOLUME Up and Down
Use these buttons to raise or lower the volume level of the Wired Headphones or External Speakers if
installed. They are also used to make adjustments in the picture mode.
NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When
using these devices, the volume must be adjusted with the headphone volume control or with
your radios volume control.
5. MENU Button
Press the MENU button. The MENU display appears. Use the Channel Up and Down buttons to select the
desired function, then press ENTER button to end the choice.
6. TV/VIDEO Button
Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the button is
pressed, the on-screen display will cycle as follows:
7. MUTE Button
Press this button to turn the TV sound off. Press again to restore sound to the previously set level. MUTE
may also be released by pressing the VOLUME +/-.
8 When tuned to a channel press this button to store or erase the channel from memory. The stored channel
numbers are displayed in GREEN on the screen and the no stored channel numbers are in RED.
9. AUTO PROGRAM Button
Select the regular channel broadcast TV or CABLE TV for AUTO PROGRAM. All the channel numbers for
TV or CABLE TV will be scanned. The broadcasting signals will be detected and automatically stored.
10. ENTER Button
Use this button to end the choice on the menu.
11. PICTURE SELECT Button
Each time this button is pressed the on-screen picture adjustment display cycles through “adjustment
screens” as follows:
TV AV1 AV2 AUX
BRIGHTNESS CONTRAST COLOR SHARPNESS TINT