SCHOEPS Double MS Tool BF (2012) - Manual (Page 5)

Double MS Plugin Installation, Setup and Userguide
3. Back to the mixer: now route the outputs of your raw
Double MS tracks to the newly created surround bus. In
most cases you want to route the output of the Double
MS bus directly to the surround master.
4. Now adjust the pannings of you raw channels as
following: rightclick on the surround panner and select the
„Matrix - Mode“ in
the panning
window. Now you
can easily set the
output levels:
• Front: 0dB to L
• Side: 0dB to R
• Rear: 0dB to C
5. Finally insert the
Double MS Plugin
into your Double
MS surround bus.
5
Side:
Rear:
Front: