SCHOEPS Double MS Tool BF (2012) - Manual (Page 8)

Double MS Plugin Installation, Setup and Userguide
1. Add your raw Double MS tracks to your virtual
project.
2. In the mixer window, goto the configure page and
select ,Add bus -> Mono mix‘.
3. Create a 8 channel multi mono bus without any
channel configuration. You have also to create a
5.0 surround strip.
4. Back in the ,Mix !‘ page,
configure the routing
as following: at first,
turn off the master
output of the three raw
Double MS channel
strips. Now select the
output matrix to the
recently created multi
mono bus:
• Front to channel 1
• Side to channel 2
• Rear to channel 3
5. Now route the outputs back to the
created surround strip:
• L: output 1
• C: output 3
• R: output 2
• Ls: output 4
• Rs: output 5
6. Finally insert the Double MS Tool BF
into the multi mono bus.
8