Sky-Watcher AutoTracking114(old) - Manual (Page 10)

SCAN
The SCAN function allows for scaning among all the stored positions
one by one without a stop at each position. There is not waiting at the
end of each scan cycle. Hold the "GO" key and press the key to
activate the "SCAN" function (Fig.p).
ERASE A STORED POSITION
If you want to permanently erase a set position, return the mount to
the Reference Position. Turn the power off and then turn it back on
again. Hold down the "SET" button and press the numeric key
corresponding to the position you want to erase. This is to override the
previous stored information with 0. In the CRUISE and SCAN modes,
the mount will recognize this and bypass this position and go to the
next position instead.
10
GUIDE
SET GO
SLOW
FAST
1
2
3
4
6
5
CRUISE
TRAC
SET LAT
Fig.p
GUIDE
SET GO
SLOW
FAST
1
2
3
4
6
5
CRUISE
TRAC
SET LAT
Fig.q
The mount allows a total of 6 stored positions. If there is a vacant
one available, it is recommended that you store the Reference
Position for quick access in the future.
To stop the mount during "GOTO", "Cruise", and "Scan" functions,
press the and keys simultaneously (Fig.q). After a command
has been implemented, all keys have to be released before the
mount accepts the next command. During the "GOTO", "Cruise",
and "Scan", the mount only reacts to the stop key combination.