Sky-Watcher AutoTracking114(old) - Manual (Page 9)

9
GUIDE
SET GO
SLOW
FAST
1
2
3
4
6
5
CRUISE
TRAC
SET LAT
Fig.o CRUISE
The CRUISE mode is usable if you want the mount to stop for several
seconds at each stored position during slewing. To activate the
CRUISE function, press "SET" and "GO" keys in combination (Fig.o).
The mount will cruise sequentially among the stored positions. The
mount will stay in each position for 5 seconds and then move on to the
next position. After one cycle, the mount will stop at the last position
for 3 minutes and the cruising cycle will start over again. You can
bypass the waiting period of 3 minutes by pressing the "fast" key and
the cycle will then start right away.
In the cruise mode, the "SET" and "GO" keys will remain lit
throughout the cycle and the numeric key the mount is moving to
will flash.
If the multifunction mount is connected to an Acuter digital spotting scope or Canon EOS digital
camera (see Auto Imaging below), in the cruise mode, the mount will automatically send a signal
for the digital imaging device to take a shot every time it reaches a stored position. If you do not
wish to activate this function, simply remove the connecting cable between the multifunction
mount and the digital imaging device.
Auto Imaging
AUX Power
DC Power
HC
AUX
Electronic shutter interface. This controls software action from the
mount to devices such as digital spotting scope or Canon EOS
digital cameras.
Power supply socket for other devices. This is for auxiliary power
from the mount to devices such as digital spotting scope or digital
camera. The output voltage is the same as DC power.
For optional DC 12-volt source to power the mount.
For connection to the hand control.
Not in use.
AUX
HC
Auto Imaging
Aux Power
DC Power
Power Switch