Sound Devices 552 - Manual (Page 43)

552 User Guide and Technical Information
39
Accessing the Setup Menu
The Setup Menu controls a wide range of 552 settings. To enter the Setup Menu, press and hold the
Battery Check button then press the Headphone Controller. Turn the Headphone Controller to scroll
through the menu. Press the Headphone Controller to enter Functions and to select options. To exit
the Setup Menu, press any key other than the Headphone Controller. The Setup Menu is locked out
while record mode is active.
1. Press and hold the Battery Check Button.
2. Press in on the Headphone Controller.
1.
2.
Turn to navigate through the Setup
Menu functions and options.
Press to enter Setup Menu functions, press again to
select and option and exit Setup Menu Function.
Right Meter LEDs indicates the
active option for the select Function.
Left Meter LEDs indicate Setup
Menu Functions.
Flashing LEDs indicate the selected
Setup Menu Function or option.
Solid LEDs indicate the active
Setup Menu Function or option.
User Settings
The 552 can save and recall a User Setup File from the SD card or its internal memory. User Setup
Files contain all settings made in the Setup Menu and all Input Settings including, input type, phan-
tom power, and polarity. To save a User Setup:
1. To save to internal memory : Hold Input 2’s PFL then press the Stop button. SVEN announces “Save
Settings to internal memory. Press Battery Button if ok, press Stop to cancel.”
To save to SD Card : Hold Input 1’s PFL then press the Stop button. SVEN announces “Save Settings to
SD card. Press Battery Button if ok, press Stop to cancel.”
2. Press the Battery Check Button. To cancel, press the Stop key. If neither button is pressed in five seconds,
the save settings function is canceled. When saving, the REC LED illuminates a constant yellow. Wait
until SVEN announces “Save complete” and the LED turns off before performing any other action.
A User Setup that is saved to the internal memory will remain on the 552 across power cycles. Saving
a new User Setup to internal memory will replace the previous User Setup in internal memory. A
User Setup that is saved to the SD card will be saved in the form of a file is named SDMIX552.SUP
and is placed in the SOUNDDEV folder on the SD card.
To load a User Setup:
1. To load from internal memory : Hold Input 2’s PFL then press the Headphone Controller. SVEN an-
nounces “Load Settings from internal memory. Press Battery Button if ok, press Stop to cancel.”
To load from SD card : Hold Input 1’s PFL then press the Headphone Controller. SVEN announces
“Load Settings from SD card. Press Battery Button if ok, press Stop to cancel.”