TDK TVT1001 - Manual (Page 12)

12
SETUP (CONTINUED)
B. TO USE WITH A UNIT WITH LINE IN JACK (HOME STEREO, BOOM BOX, ETC.):
NOTES:
• When connecting the unit, refer to the owner’s manual
of the external unit, as well as this manual.
• Make sure the power is off and both units are unplugged
before making any connections.
6b. Connect the left and right plugs of the Audio Cable
(included) to the Left and Right Out jacks on the rear
of this unit, matching the red to red and white to white.
Connect the other end of the Audio Cable to the Line In
jacks of the Home Stereo or similar equipment.
Warning Regarding the PRE-AMP Switch
This unit is equipped with a moving magnet phono
preamplifier with RIAA equalization. This is a very convenient
addition for those customers not possessing an amplifier or receiver with a phono input. However, caution
should be applied to the use of this preamplifier. When you are using this preamplifier’s output as indicated
by the “ON” designation of the switch located on the back center panel of the turntable, do not under any
circumstances connect the RCA output connectors of the turntable to the input connections of an additional
phono preamplifier on a receiver or amplifier often marked “Phono Input”. Excess gain from the use of the
preamplifier in the turntable as well as the preamplifier in your amplifier or receiver may cause damage to
your amplifier and/or speakers.
OUTPUT R L
R L
R L
Amplifier
Turntable