TDK TVT1001 - Manual (Page 9)

9
SETUP
After unpacking, set up the unit as follows:
1. Gently place the Platter onto the Spindle,
making certain that the Platter is fully seated
before proceeding to the next step.
2. Place the Platter Cover onto the Platter.
3a. Remove the plastic
cover from the stylus.
3b. Gently pull the Drive Belt around the Motor
Pulley. Be careful to not allow finger grease or
other contamination to foul the belt.
NOTE:
The Drive Belt comes installed around the Platter.
4. Place the Motor Cover onto the Motor,
making sure each side has the Drive Belt
coming through.