TeachLogic Airlink Router - Manual (Page 12)

transmitter
operating the AirLink router system
Initially have all controls at minimum level
Turn on transmitter and receiver units
Turn on transmitter and receiver modules
LCD window will light and channel # display
Tx LED (Yellow) on transmitter will light
(indicating transmission)
Rx LED (Yellow) on receiver will light
(receiving transmission)
A/B LED (Red or Green) diversity ant. receiving
Select transmission channel
Press and hold “SET” button for one second
Number in LCD will start flashing
Press UP or DOWN arrow to select desired
channel
Press “SET” button to lock channel selected
Repeat procedure on receiver
Transmitter and receiver must be on same channel
Insert an audio signal into either input of
transmitter
Push in respective mute switch
(Small square red button)
Tx (Red LED) indicates audio is being passed
to transmitter
Adjust input gain until AF (Green LED)
transmitter module flashes
Adjust master volume on transmitter module
until AF (Green LED) on receiver starts flashing
Adjust gain control of receiver for desired output
level
Headphone Output
Monitors the auxiliary input (RCA) only
Line out
Dual RCA jack: Line level output—Pre-fader
Microphone Input (1/4” phone)
Low level line or condenser microphone input
(1/4” phone)
12
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
6
AirLink
owner’s manual
6