Trail Master Suspension TM407N FORD F-150 4WD 6 SUSPENSION LIFT KIT - Manual (Page 9)

9
TM407N
Revised
6.14.13
f. Inspect again for steering shaft and steer-
ing U-joint clearance at the frame. If no con-
tact is made and the steering shaft has no
interference, proceed with step h.
g. If the steering shaft and/or steering U-joint
still has/have interference at the frame, re-
configure kit rack & pinion spacers to create
½” drop
h. Check for steering shaft clearance to frame
and band clamps, the dust boots and the
clamps may have to be repositioned or re-
moved. Torque the kit 5/8” bolt to 150 ft./lbs.
and the OE bolts to manufacturers specifica-
tions.
i. Repeat assembly on opposite side of vehi-
cle.
2. Install kit passenger side differential
bracket.
a. Slide kit passenger side differential
bracket into factory passenger side differen-
tial mount so that large tab with two holes on
bracket faces towards rear of vehicle.
b. Secure using OE bolt, do not tighten at this
time.
3.Install kit driver side differential bracket.
a. Slide kit driver side differential bracket
into factory driver side differential mount.
b. Secure using OE bolt, do not tighten at this
time.
4. Mount differential.
a. Position differential into kit brackets previ-
ously installed.
Kit Passenger
side differential
bracket
82-TM241008
Kit Drive side
differential
bracket
82-TM241007
differential
Kit Passenger
side differen-
tial bracket
Kit Driver side
differential
bracket
differential