Trail Master Suspension TM3335-40013 w/Arms & Nitro shocks JEEP WRANGLER 4 DOOR (JK) 3.5 SPRING KIT - Manual (Page 5)

5
5. Torque the 5/16” hardware to 25 ft./lbs. and the
OE bolt to 125 ft./lbs.
6. On the passenger side, with the axle supported,
remove the passenger side upper and lower
control arm from the vehicle. Be sure to leave
the driver side control arms in place to keep the
front axle from rolling over. Using a chisel, re-
move the alignment plates from the factory
mounts.
7. Install the arm (82-TM30006) into the mounting
pockets on the frame using the previously re-
moved OE bolts and the supplied alignment
plates.
8. Rotate the plates so that the large lobe is facing
toward the front of the vehicle. Torque to 95 ft./
lbs.
9. Repeat steps 6 through 8 on the remaining side
of the vehicle.
10. Place the front bump stop extension (90-
TM10001) on the lower spring mount. Center
the extension and mark with a center punch.
11. Use the previously applied mark to drill a hole in
the lower spring mount using a 5/16” drill bit.
Pre tap the hole using the supplied 3/8” X 2”
self tapping screw.
90-TM10001
Bump Stop
Extension
Front
Axle
35-TM20041
Alignment
Plate
TM3335-
60020 Front
Coil Spring
90-TM10001
Bump Stop
Extension
Front
Axle
OE Bolts
82-TM30006
Control Arm