Trail Master Suspension TM3335-40013 w/Arms & Nitro shocks JEEP WRANGLER 4 DOOR (JK) 3.5 SPRING KIT - Manual (Page 6)

6
12. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (TM3335-60020) into
the spring buckets
13. Install the coil spring and bump stop spacer at
the same time. Secure the bump stop extension
using the 3/8” self tapping bolt. DO NOT over
tighten.
14. Raise the front axle into place. Make sure the
coil spring seats properly on the lower spring
perch.
15. Install your new front shocks (TM73265005) us-
ing the previously removed OE hardware.
16. Torque the OE shock hardware according to
manufacturers specifications.
17. Reinstall the OE rear sway bar end link into the
original front mounting locations using the previ-
ously removed OE hardware. Torque to manu-
facturers specifications.
18. 2007-2010 models only: Install the front brake
line brackets (35-TM20010) to the frame and
secure using the provided 1/4” X 1” bolts and
hardware.
19. 2011-2013 models only: Install the front brake
line brackets (35-TM20030 drvr and 35-
TM20031 pass) to the front axle and secure us-
ing the provided 1/4” X 1” bolts and hardware.
20. Secure the OE brake line brackets to the drop
brackets using the previously removed OE hard-
ware.
21. Remove the retaining clips that retain the ABS
wire to the OE brackets. Wrap the OE ABS
lines with the provided protective sleeves (90-
4337) and secure with the supplied zip ties
(10999).
22. Install the new pitman arm (TM3340-50020) to
the sector shaft.
23. Reinstall the Pitman arm retaining nut to the
sector shaft and torque to 185 ft./lbs.
24. Reinstall the steering drag link to the pitman arm
using the previously removed castellated nut.
Torque the drag link nut to
60 ft./lbs. Insert new
cotter pin.
25. Reinstall the front track bar to the front track bar
bracket using the supplied 14mm cam bolt (90-
3718), notched cam (90-3245) and hardware.
26. Reattach the transfer case skid plate using the
previously removed hardware. Torque the hard-
ware to
87 ft./lbs.
27. Reinstall the wheels and lower the vehicle to the
ground. Torque the lug nuts to OE specifica-
tions.
35-TM20010
Front Brake
Line Drop
OE bolt
1/4” X 1”
bolt
TM3340-50020
Pitman Arm
NOTE
Whether re-using the existing pitman arm retain-
ing nut or replacing with a new nut, thread lock-
ing compound must be used.
NOTE
The threads of the sector shaft and the Pitman
arm retaining nut MUST be cleaned using brake
cleaner or another suitable method to remove
the previously applied oil.