Trail Master Suspension TM3335-40013 w/Arms & Nitro shocks JEEP WRANGLER 4 DOOR (JK) 3.5 SPRING KIT - Manual (Page 8)

8
5. Raise the rear differential and make sure that
the coil springs are in their saddles.
6. Install the rear bump stop extensions (82-
TM20012) to the rear axle bump stop pad using
the supplied 8mm X 20mm bolts and hardware.
7. Assemble the rear sway bar end links (82-
TM30016) by install bushings (45359) and
sleeve (51792) in the top and bottom of the
sway bar end links.
8. Install sway bar end links (82-TM30016) into the
OE frame and sway bar mounting locations us-
ing the previously supplied 12mm x 60mm bolts
and hardware.
9. Install the rear brake line drop (35-TM20010) to
the OE hole in the frame using the previously
removed OE hardware.
10. Reconnect the rear brake line drop (35-
TM20010) using the supplied 5/16” X 1” bolt
and hardware.
11. Install your new front shocks (TM73265006) us-
ing the previously removed OE hardware.
12. Torque the OE shock hardware according to
manufacturers specifications.
13. Reinstall the rear track bar to the axle mount us-
ing the previously removed OE hardware.
14. Install the rear track bar to the track bar drop
bracket using the supplied 9/16” x 3” bolt and
hardware. Torque to
135 ft./lbs.
15. At full droop, cycle the steering from lock to lock
while observing the reaction of these
components. Reposition them if needed.
16. Reinstall the rear wheels and lower the vehicle
to the ground. Torque the lug nuts to factory
specifications.
17. Recheck the wheel lug torque on all four wheels
at this time.
35-TM20010
Rear Brake
Line Drop
OE bolt
5/16” X 1”
bolt
82-TM20012 Rear
Bump Stop Exten-
8mm X
20mm Bolts
82-TM30016
Sway Bar End
Link
Axle
Mount
Sway Bar
12mm x
60mm Bolt
12mm x
60mm Bolt
Bushings
45359 and
Sleeves
51792