Trail Master Suspension TM3340-40013 w/ Nitro Shocks JEEP WRANGLER 4 DOOR (JK) 4 SPRING KIT - Manual (Page 7)

7
Install Rear Suspension
1. Install the track bar drop bracket (82-TM20038)
into the track bar mounting position using the
previously removed 9/16” X 3 1/2” bolt, hard-
ware and sleeve (35-TM30037).
2. Secure the rear track bar drop bracket (82-
TM20038) to the axle using the (2) supplied 3/8”
x 1” bolt and hardware.
3. Torque the 9/16” track bar drop hardware to
135 ft./lbs and the 3/8” hardware to 40 ft./lbs.
4. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (TM3340-60030) into
the spring buckets
5. Raise the rear differential and make sure that
the coil springs are in their saddles.
6. Assemble the rear sway bar end links (82-
TM30025) by install bushings (45359) and
sleeve (51792) in the top and bottom of the
sway bar end links.
7. Install sway bar end links (82-TM30025) into the
OE frame and sway bar mounting locations us-
ing the previously supplied 12mm x 60mm bolts
and hardware.
TM3340-
60030 Rear
Coil Spring
82-TM30025
Sway Bar End
Link
Axle
Mount
Sway Bar
12mm x
60mm Bolt
12mm x
60mm Bolt
Bushings
45359 and
Sleeves
51792
Rear Upper
Coil Pocket
35-TM30037
Sleeve
82-TM20038
Track Bar
Drop Bracket
9/16” X 3
1/2” Bolt
3/8” x 1”
Bolt