Trail Master Suspension TM3340-40013 w/ Nitro Shocks JEEP WRANGLER 4 DOOR (JK) 4 SPRING KIT - Manual (Page 8)

8
8. Install the rear brake line drop (35-TM20010) to
the OE hole in the frame using the previously
removed OE hardware.
9. Reconnect the rear brake line drop (35-
TM20010) using the supplied 5/16” X 1” bolt
and hardware.
10. Install the rear bump stop extensions (82-
TM20012) to the rear axle bump stop pad using
the supplied 8mm X 20mm bolts and hardware.
11. Install your new front shocks (TM73265006) us-
ing the previously removed OE hardware.
12. Torque the OE shock hardware according to
manufacturers specifications.
13. Reinstall the rear track bar to the axle mount us-
ing the previously removed OE hardware.
14. Install the rear track bar to the track bar drop
bracket using the supplied 9/16 x 3 1/2” bolt
and hardware. Torque to
135 ft./lbs.
15. At full droop, cycle the steering from lock to lock
while observing the reaction of these
components. Reposition them if needed.
16. Reinstall the rear wheels and lower the vehicle
to the ground. Torque the lug nuts to factory
specifications.
17. Recheck the wheel lug torque on all four wheels
at this time.
18. Recheck all hardware for proper installation and
torque at this time.
19. On completion of the installation, have the head-
lights re-aligned.
20. Test drive and note location of steering wheel.
21. Adjust drag link to center steering wheel.
22. Align vehicle as soon as practical to minimum
factory caster and maximum factory toe-in
specifications.
23. After 100 miles recheck for proper torque on all
newly installed hardware.
24. Recheck all hardware for tightness after off road
use.
35-TM20010
Rear Brake
Line Drop
OE bolt
5/16” X 1”
bolt
82-TM20012 Rear
Bump Stop Exten-
8mm X
20mm Bolts