Tweco 186 DC Inverter User Manual
186 ac/dc operating manual, Inverter, Arc welding machine
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 0-5143-CCr
- SECTION 1:
SAFETY INSTRUCTIONS AND WARNINGS
- 1.01 Arc Welding Hazards
- 1.02 General Safety Information For Victor CS Regulator
- 1.03 Principal Safety Standards
- 1.04 Symbol Chart
- 1.05 Precautions De Securite En Soudage A L’arc
- 1.06 Dangers relatifs au soudage à l’arc
- 1.07 Informations Générales de Sécurité
- 1.08 Principales Normes De Securite
- 1.09 Graphique de Symbole
- 1.10 Declaration Of Conformity
- SECTION 2: INTRODUCTION
- SECTION 3:
INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 High Frequency Introduction
- 3.06 High Frequency Interference
- 3.07 Electromagnetic Compatibility
- 3.08 186 AC/DC Power Source Controls, Indicators and Features
- 3.09 186 AC/DC - STICK Programming Mode
- 3.10 186 AC/DC – LIFT TIG and HF TIG Programming Mode
- 3.11 Short Circuit Protection While Welding
- 3.12 Victor Regulator
- 3.13 Specification for TIG Torch
- 3.14 Setup for TIG (GTAW) Welding
- 3.15 Setup for STICK (SMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6: KEY SPARE PARTS
- APPENDIX 1 : CIRCUIT DIAGRAM
- APPENDIX 2 : 186 AC/DC SETUP GUIDE
- SECTION 1: SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 175i Power Source Controls, Indicators and Features
- 3.07 Attaching the Tweco Professional Fusion Mig Torch (Euro)
- 3.08 Installing Minispool (100mm diameter)
- 3.09 Installing Handispool (200mm diameter)
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- AP0-5143-APENDIX