06 user responsibility, 07 transporting methods, 08 packaged items – Tweco 186 DC Inverter User Manual
Page 26: Introduction 186 ac/dc inverter
INTRODUCTION 186 AC/DC INVERTER
INTRODUCTION
2-2
Manual 0-5237
2.05 User Responsibility
This equipment will perform as per the information con-
tained herein when installed, operated, maintained and
repaired in accordance with the instructions provided.
This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used.
Parts that are broken, missing, plainly worn, distorted or
contaminated, should be replaced immediately. Should
such repairs or replacements become necessary, it is
recommended that such repairs be carried out by ap-
propriately qualified persons approved by Thermal Arc.
Advice in this regard can be obtained by contacting an
Accredited Thermal Arc Distributor.
This equipment or any of its parts should not be altered
from standard specification without prior written ap-
proval of Thermal Arc. The user of this equipment shall
have the sole responsibility for any malfunction which
results from improper use or unauthorized modifica-
tion from standard specification, faulty maintenance,
damage or improper repair by anyone other than ap-
propriately qualified persons approved by Thermal Arc.
2.06 Transporting Methods
This unit is equipped with a handle for carrying pur-
poses.
!
WARNING
ELECTRIC SHOCK can kill. DO NOT TOUCH
live electrical parts. Disconnect input power
conductors from de-energized supply line
before moving the welding power source.
!
WARNING
FALLING EQUIPMENT can cause serious
personal injury and equipment damage.
Lift unit with handle on top of case.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure unit on a
proper skid before transporting.
2.07 Packaged Items
• 186 AC/DC Inverter Power Source
• Tweco 200 Amp Electrode Holder with 13ft (4m)
Lead
• Tweco 200 Amp Work Clamp with 10ft (3m) Lead
• 26 TIG Torch 13ft (4m) Lead with Integrated
Controls & Accessory
• 9ft (2.75m) Power Cord and NEMA6-50P 230V
AC Plug
• Victor Argon Flow Gauge & 12.5 ft (3.8m) Hose
• 4 General Purpose Stick Electrodes (E6013)
• Shoulder Strap
• Operating Manual & CD
• Thermal Arc Cap
Figure 2-1: 186 AC/DC Packaged System