Valco Baby Twin Tri Mode - Manual (Page 5)

IMPORTANT WARNING: Always test that all latches are securely engaged before use.
Installing/Removing the rear wheels
Unfold the chassis:
1. Holding the rear centre leg, lift
the stroller upwards.
2. Pull the centre leg outwards as
far as it can go.
3. Lift the handle upward and back to
a vertical position.
4. Secure the handle by swinging the
locking clamps (located on both sides
of the frame) and fully engaging them
tightly onto the frame.
5. Press down on the basket frame
locking hinge with your hand or
foot.
1. Pressing on the centre hub
button, insert the SQR axle
through the outside of the hub in
each wheel.
IMPORTANT: Insert through outside
of the wheel (the side which does
NOT have the nylon brake cog).