CDA SV451 - Manual (Page 9)

Fig. 10
General Settings and Use
Clock
To set the clock when the time is flashing (for example, at first
switch on) touch or until the correct time shows on the
display, then touch to confirm the selection. There will be
two beeps to confirm the selection and the clock will stop
flashing.
To set the clock once the time has been set (when the clock
is not flashing) touch , then touch twice until the clock
flashes. Touch or until the correct time shows on
the display, then touch to confirm the selection. The
microwave will beep twice to confirm the selection and the
clock will stop flashing.
Childlock
This appliance is equipped with a childlock to prevent
accidental use. For safety reasons the key will work to
switch the appliance off when the childlock is set.
To switch the childlock on or off, touch and hold for
approximately five seconds until shows in the top left
corner of the display (as shown in figure 10) and there are two
beeps to confirm the selection.
When the childlock is on, shows in the display and will
flash if any key is touched.
Contrast adjustment
To adjust the contrast on the display, touch and then touch
and hold for approximately seven seconds until -CO- shows
on the display as shown in (figure 11). Touch or until the
contrast is at the required level, then touch to confirm the
selection.
Minute minder
This appliance is equipped with a minute minder that can
be used when there is no programme selected. The minute
minder can run for a maximum of 60 minutes. To set the
minute minder, touch and then . Touch and until
the required time shows on the display and touch to start
the minute minder.
The display will show the current time and . At the end
of the countdown, will flash and the appliance will beep
intermittently for approximately 80 seconds. To stop the end
of timer alerts before that time, touch .
Fig. 11
8