Winchester Repeating Arms X Pump (SXP) - Manual (Page 21)

always insPeCt the ChaMber, barrel, Feed
MeChanisM and MagaZine CareFully aFter
unloading to be sure all live shells are
Cleared FroM the FirearM.
u nloADinG bY c YclinG the A ction
Perform the following steps to remove shells from the
chamber and magazine on all Super X Pump models.
1. Place the “safety” in the on safe position.
2. Press the disconnector release button to release the
slide (Figure 6, page 13).
3. Slide the forearm through a complete cycle of the
action and repeat the process until all the shells in the
magazine have been transferred to the chamber and
then ejected.
4. When the last shell in the magazine has been cycled
through the chamber and out the ejection port, leave
the action open.
5. Using your index finger, feel the entry of the
magazine to make sure there are no longer any
shells in the magazine.
u nloADinG From the m AGAzine
The shells can also be removed from the magazine by
following these steps:
1. Place the “safety” in the on safe position, make sure
the action is closed and keep the muzzle pointing in
a safe direction.
2. Turn the firearm over so the trigger guard is facing up,
then push the carrier down as far as it will go.
3. Push inward on the shell stop to release a shell
from the magazine (Figure 10). Press the shell stop
again to release the second shell. The shell stop is
located on the inside-right of the ejection port.
When a shell is in the magazine the shell stop rests
on the brass of the shell.
19
FIGURE 10
Press the shell stop inward to
release shell from magazine.