Winchester Repeating Arms X Pump (SXP) - Manual (Page 31)

29
3. To reinstall the bolt assembly on the slide arm, push
or compress the knob end of the firing pin sufficiently
into the hole in the bolt slide so that the large space
between the grooved knob and the flange on the
firing pin is centered in the round hole in the
bolt slide.
4. Place the curved tongue, located on the slide arm,
into the space between the knob and flange and
slowly release pressure on the end of the firing pin.
Let the flange on the firing pin pull the tongue toward
the rear of the bolt assembly.
5. Remove the magazine cap.
6. Hold the slide arms and bolt/slide arm assemblies
together (Figure 14). Start the forearm assembly onto
the magazine tube.
7. Carefully guide the slide arms and bolt/slide arm
assemblies into the front of the receiver. As the
assemblies enter the receiver, slide them fully
rearward (Figure 15).
r einstAllAtion oF the t riGGer G roup
1. The bolt assembly, slide arms and forearm should
be attached to the receiver before installing the
trigger group.
FIGURE 15
Carefully guide the bolt assembly — on the
slide arms — into the receiver.
FIGURE 14
Position the bolt assembly on the slide arms.