Exide Technologies GB4109 User Manual
Page 5
Sales x Service x Recycling 888.563.6300 in the USA 800.268.2698 in Canada
2
¾
Risk of electrical component failure due to improper installation. To prevent damage from
overheating, proper airflow must be ensured. Do not restrict fan inlets or exhaust outlets. Do not
mount the charger in a confined space or where the exhaust air will recirculate.
¾
There are no user serviceable parts within the charger enclosure. If service is required, contact the
local GNB Industrial Power service representative.
¾
The charger is NOT for outdoor use. Do
not expose the charger to rain or snow.
¾
Do not disconnect the battery while under charge.
IMPORTANT:
¾
Follow the battery manufacturer's published instructions when installing, charging and servicing
batteries.
¾
These instructions assume a certain level of competence by the installer and/or user. The following
practices and codes contain relevant information, and should be consulted for safe handling,
installation, testing, and maintaining deep cycle batteries. Applicable state and local codes must be
followed.
x
NESC, National Electric Safety Code, ANSI C2-1993 (or latest revision). Copies may be
obtained by writing:
The Institute of Electrical and Electronics Engineers, Inc.
345 East 47
th
Street, New York, NY 10017, USA
x
NEC National Electrical Code NFPA-70 (or latest version) available from: National Fire
Protection Association, Batterymarch Park, Quincy, MA 02269
x
Federal Codes:
29CFR1926.441 "Safety Requirements for Special Equipment"
29CFR1910.151(c) "Medical Services and First Aid"
29CFR1910.305(j) "Wiring Methods, Components and Equipment"
STD 1-8.2(e) "OSHA Standing Directive"
x
EMC Compliance:
This device complies with Part 15 section 103 of FCC Rules as a digital device used exclusively
as a power system in public utilities or industrial plants.
Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received, including interference that may
cause undesired operation.