Exide Technologies GB4109 User Manual
Page 8
Sales x Service x Recycling 888.563.6300 in the USA 800.268.2698 in Canada
5
CAUTION: When installing, do not lift the unit from the middle of the lower cover as this
may damage the filter. To reduce potential for filter damage, lift the charger using the
lifting handles mounted on either side of the charger chassis (see Figure 2).
Figure 2: Charger lifting instructions
III. Installing / Removing Air Filter
The charger is equipped with an air filter located in the lower cover of the unit. The air
filter needs to be checked on a regular basis and cleaned if needed.
ATTENTION: To clean the filter, use soap and water; dry thoroughly before
installing.
To remove the filter, hold the open end of the filter and slide out. To re-install, slide the
filter into the lower cover guide and push in until fully inserted (Figure 3).
Lifting
Handles