Wichita Clutch Fluid Coupling - Manual (Page 13)

Mesur-Fil Fluid Couplings
166 Wichita Clutch 800-964-3262 P-1100-WC 1/12
Modular Design Concept
Sizes 7.0, 9.4, 12.4
Configuration
HSD
The Model HSD Fluid Coupling consists of a basic fluid coupling,
input and output group, and a standard customer supplied QD type
sheave. Hydro-sheave cou plings provide minimal overhung loads
for parallel (belt-driven) ap pli ca tions. The sheave is mount ed on a
coupling installed on the end of a drive shaft.
Mesur-Fil Couplings can be installed very quickly and easily
utilizing a slotted collet for mount ing on the motor shaft instead of
the center bolt that is most com mon ly used with other sheave
drives. Unlike the center bolt, the slotted collet requires no drilling
and tapping of the end of the motor shaft. The slotted collet is
finished bored to fit standard NEMA B motor shaft di men sions.
Available bore sizes are found elsewhere in this bro chure.
HCF
Consists of Model HC and input group. The input group is finish
bored to fit standard NEMA B motor shafts. The optional output
groups available (HCM, HBM) are shown on this page or the HCF
output group must be supplied by the customer. Consult
engineering for details.
HCM
The Model HCM Fluid Coupling is a complete unit with both input
and output flanges. It is intended for in stal la tion between two
halves of a double en gage ment gear tooth flexible coupling which
is customer supplied.
HBM
This coupling is a complete unit with a straight input and output
shaft. It is installed between two piloting type flexible couplings
supplied by the customer.