Wichita Clutch Fluid Coupling - Manual (Page 6)

C
Mesur-Fil Fluid Couplings
P-1100-WC 1/12 Wichita Clutch 800-964-3262 159
G
The Model HCM Fluid Coupling is a complete unit with both
input and output flanges. It is intended for in stal la tion between
two halves of a double en gage ment gear tooth flexible
coupling which is customer supplied. This ar range ment
provides for a wide range of input and output configurations
for ease of installation.
HC Sizes 7.0-12.4 Input and Output customer supplied.
(page 168)
This is a basic coupling with an input bore for direct
mounting on the motor shaft end and a convenient bolt
circle for customer-designed output configurations.
HCM
(pages 170-171)
Hydro-sheave couplings are mounted to the motor shaft end
and provide minimal overhung loads for parallel (belt-driven)
shaft applications. The smaller sizes (7-12.4) are installed very
quickly and easily utilizing a slotted collet in which no drilling or
tapping is required. The slotted collet is finished bored to fit
standard NEMA B motor shaft dimensions. The larger sizes
(15-24) are installed with a center locating bolt that does
require drilling and tapping to ensure proper mounting.
The Model HSD Fluid Coupling consists of a basic fluid
coupling, input and output group, and a standard customer
supplied QD type sheave. The sheave is mount ed on a coupling
that has been installed on the end of a driveshaft.
HSD
(pages 172-173 )
This coupling is a complete unit with straight input and
output shaft. It is installed between two piloting type flexible
couplings supplied by the customer. HBM Sizes 7–12.4
(page 169)