Crimestopper Security Products CS-2012DP-TW1 - Manual (Page 21)

21
OPTION PROGRAMMING TABLE
20 PINK Wire function Carjack *Glow Plug*
21
Starter Cranking Time (Option #16
is set to Timed Crank)
0.75 Sec. *0.5 Sec.* 1.0 Sec. 1.5 Sec.
22 Diesel Glow Plug Delay 10 Seconds *Monitor Glow Plug 20 Seconds 30 Seconds
23 Remote Start Engine Run Time 12 Minutes *24 Minutes* 36 Minutes 48 Minutes
24
Smart Tachless Voltage Adjustment
79-100%
-1% 1%
*Set to 93% for
default*
25 Horn Pulse
Pulse With Trigger
(No Chirps)
No Warn-A-Way *All Functions*
26 Aux # 3 Steady Momentary *Momentary* Timed Latch On/Off
27 Aux # 3 Time : 1 to 255 sec. -1 Second +1 Second *Default 12 Sec.*
28 Aux # 4 Steady Momentary *Momentary* Timed Latch On/Off
29 Aux # 4 Time : 1 to 255 sec. -1 Second +1 Second *Default 12 Sec.*
30 Reset Options to default (*) *Reset All Options*
PROGRAMMABLE OPTION DESCRIPTIONS:
1. ENGINE MONITORING:
This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a
Tach signal (RPM) or for “Ultra-Smart” Tachless mode that monitors voltage level. See pages 15-16 for more
information and additional steps for actual Tach learning and Tach finder modes.
2. AUTOLOCK/UNLOCK W/IGNITION:
Controls whether the doors will automatically lock when the ignition is turned on and unlock when the ignition is
turned off. Doors will not lock if they are open to prevent locking the keys in.
3. PASSIVE ARMING Passive Arming With Ignition or Last Door:
With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and/or the last door has been
closed. Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the
system will wait and begin countdown again when closed. The LED will flash rapidly during 30 second count down.