Monarch Instrument Track-It - Manual (Page 6)

Track-It User Guide
Page 6 Rev 1.02 06/21/11
3.2.4. Upload Device Data
This allows the user to retrieve the current recorded data in the device. If selected it will ask for a file name. This operation
will stop any recording currently in progress on the device. If there is no recorded data in the device you will get a message
to that effect.
3.2.5. Exit
Close and exit the program
3.3. Preferences
There are basic settings that need to be set up by the u
ser if the defaults are not acceptable. Select “Preferences “ from the
menu at the top of the window. This will pop up the preferences window shown below.
3.3.1. The General Tab
This page has several settings that affect the way data is displayed.
3.3.1.1. Decimal Places
Selects the number of decimal places that numeric data
will display
3.3.1.2. Graphic Display 24 Hr Format
If checked time on the graph will be displayed in 24 hour
format. If unchecked time will be displayed in 12 hour
format with AM and PM indication
3.3.1.3. Temperature
Selects the temperature units used by this program
locally °C or °F. Note the Logger Device always uses °C
internally.
3.3.1.4. Languages
Selects the language that all dialogs will be presented in.
This requires language specific file "language.csv" that is
configured for the languages required. The default is English.
3.3.1.5. Date Format
Selects the format that the date is presented. Select your preference from the pull down menu.
3.3.1.6. Cursor Snap to Point
Determines whether the cursor will snap (jump) to the actual data point on a line
– check Yes, or move along the
extrapolation of the line – check No.
3.3.1.7. Recall Directory
If checked Yes the program will remember the last directory used and will default to this at each start up.
3.3.1.8. Use Channel Tag
If checked Yes
– uses the user supplied channel Tag as set in the Device Setup - Input tab else uses the generic
labels Chan 1 or Chan 2.
3.3.1.9. Autoload Config
If checked Yes
– each time the Device Setup tab is selected the program will load the configuration from the
logger, provided the logger is attached to the USB port. If checked No – the user will need to load the
configuration manually, either from the device or the PC. When navigating away from Device Setup and back, the
configuration will remain intact once loaded.
3.3.1.10. Real Time Data
– Sample Rate
When sampling and displaying in real time this selects the real time sample update rate