Monarch Instrument Track-It - Manual (Page 7)

Track-It User Guide
Page 7 Rev 1.02 06/21/11
3.3.1.11. Real Time Data
– Samples per Screen
Use the pull down menu to select how many samples fill the screen before the graph starts to auto scroll. The
user can still choose to compress the data at a later stage.
3.3.1.12. Real Time Data
– Data type
Select whether to show data as Instant – each data point is displayed as is, Max or Min will show the peak value
high or low, Average will average the readings. Note that a 2 second sample rate is the maximum sample rate
and essentially all points will be instantaneous.
3.3.1.13. Real Time Data
– Save Data
Check Yes to record data to your local storage medium. When choosing to display live data in the graphic window
you will be asked to select a data file to save the data to.
3.3.1.14. Real Time Data - Digital Display
If checked Yes - adds a digital display on the left hand side of the graphic window during LIVE
display.
Note: Right Clicking on the Digital Display pops up a window allowing selection of colors.
3.3.2. Pressure Scale Tab
Select this tab to select the units used by this program locally to display pressure (specific to certain loggers only). Note this
does not affect the logger which always uses its default units (KPa). The scale factor from selected engineering units to kPA
is shown and may be adjusted by the user.
3.3.3. MKT - Mean Kinetic Temperature.
The user can enter the values that are used to calculate Mean Kinetic Temperature.
3.4. Device
The Device option refers to the Logger plugged into the USB port on the PC
3.4.1. Device List
This will show the device(s) currently connected or available to the PC. Select the device
you will be working with by checking the box and then press the “Connect” button.
3.4.2. Device Info
This shows the information about the current connect device. It shows memory capacity, device type, the current firmware
revision and the device serial number.
3.4.3. Upload Device Data
This allows the user to retrieve the current recorded data in the device. If selected it will ask for a file name.This operation
will stop any recording currently in progress on the device. If there is no recorded data in the device you will get a message
to that effect.
3.4.4. Record Status
This will show the current recording status of the device – On or Off. The status can be changed selected the desired state.
3.5. Help
Selecting the “Help” menu item pops up the help selection. There are two choices:
3.5.1. Manual
Brings up this user manual
3.5.2. About
Pops up a window showing the software revision