Writing the configuration – Monarch Instrument Android Application User Manual
Page 12
RFID Logger Android App User Guide
Page 12
7.4. WRITING THE CONFIGURATION
Once all your configuration settings have been set, or you simply want to use the existing
setup, you need to start the logger by writing this information to the logger. To do this you
need to be in the configuration GENERAL tab shown right.
The write configuration button is at the bottom of the page.
In order to write to the logger you must MOVE THE LOGGER
AWAY FROM THE PHONE or tablet.
Tap the CONFIG WRITE ENABLE button which will enable the write operation. This is indicated as shown
below:
Now tap the WRITE CONFIG TO LOGGER button
This will pop up the following message:
Move the logger close to your phone/tablet in the NFC
antenna area. The program will start writing to the
logger once it is detected. Follow the instructions. The
process takes less than 3 seconds.
Note
Once the information is written, it is
automatically read back to compare and ensure the
data was written correctly.
You will not be able to write the configuration
for one type of logger to a different type of logger.
If the write fails, move the logger away and repeat the
process, ensuring that the logger is properly positioned
in the NFC antenna area.
Once the write is completed – tap the “OK” button. Use the Android back button
to return to the