Monarch Instrument RFID LOGGER - Manual (Page 3)

Page 3 Rev 1.0 03122014 AJW
On the “Confirm Installation” screen click the “Next >” button. The software will be installed.
Note: This program requires the DotNet component. If it is not found on the system it will be installed. When
completed click the “Close” button. A short cut icon (shown here) will be placed on the desktop.
3. USB RFID Interface Box
In order to read the RFID Loggers on a PC you need to have the USB RFID Interface
Box (part number 5396-9920). This Interface Box plugs into any PC USB port using
the supplied USB 2.0 A Male to Mini-B 4 pin Male cable.
The RFID Interface Box is identified as an HID-compliant device by Windows and
does not require any special drivers. When the unit is first plugged in it may take a
few minutes until the device is recognized and ready.
The Interface Box must be active before running the software
program. The green LED on the top panel should blink at a 1
second rate if the device is ready. The LED remains on while data
is read or written to the device.
Ensure the RFID Logger is placed on the designated spot on the
Interface Box (shown left) to ensure reliable communication.