Monarch Instrument RFID LOGGER - Manual (Page 6)

Page 6 Rev 1.0 03122014 AJW
4.3. Quick Load Icons
The four function buttons at the top right of the screen allow for data
uploads.
Upload data from Logger - This loads the data from a logger in the USB Interface Box. The user has the option
to save this data to the PC hard drive. Equivalent to “Device – Upload Device data” above.
Upload data from file – This loads previously saved data from a .dat file from the PC hard drive.
Upload Quick Summary from Logger - This will load and display
a quick summary from the Logger in a pop-up window. This
shows the current status of the Logger. It identifies the Logger,
shows the start time, time of the last sample, the record status, the
number of samples recorded and the battery condition. It also shows
the current alarm status.
Record status can be ON – Logger is recording, OFF – Logger is not
recording due to termination by button or is armed and is waiting to
record (waiting for delay time or button press) and Memory Full which
indicates the logger has completed the record cycle.
This information can be printed using the PRINT button or the window
can be closed using the CLOSE button. Note that if the window is left
open and Auto Close is checked in the preferences, the window will
close itself after 5 minute.
Upload Quick Summary from File - This will load and display a
quick summary from a previously saved data in a pop-up window.
The information is the same as described above.