Great Plains PT8030 Parts Manual - Manual (Page 5)

2
Assembly and Setup
PT6030 and PT8030 Pull-Type Planter 401-032Q 10/14/08
Great Plains Mfg., Inc.
The following headings are step-by-step instructions for
assembling the planter. Begin with
Tools Required and
Pre-Assembly Checklist to make sure you have all neces-
sary parts and equipment. Then proceed with
Planter Set-
up. Follow each step to make the job as quick and safe as
possible and produce a properly working machine.
The planter is shipped via flat bed truck. It is the dealer’s
responsibility to unload the new machine. Unload all
equipment before beginning assembly. Do not attempt any
assembly work while the planter is on the truck.
Tools Required
•
Forklift with 5,000 pound capacity
•
Lifting chains
•
General hand tools
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 0 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of ob-
structions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with the drill.
6. Have a copy of the parts manual on hand. If unsure of
proper placement or use of any part or fastener, refer
to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
8. Check for proper tension and alignment on all drive
chains.
9. Check that all safety labels and reflectors are correctly
located and legible. Replace if improperly located or
damaged. Refer to
Safety Decals, “Important Safety
Information” in the operator’s manual.
10. Inflate tires to recommended pressure as listed on the
Tire Inflation Chart on the “Appendix” on page 7.
Tighten wheel bolts as specified on
Torque Values
Chart on the “Appendix” on page 7.
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.
Assembly and Setup
Planter Setup
!
DANGER!
Crushing hazard. You may be severely injured or killed if the
planter falls. Securely attach planter to lifting equipment. Do
not walk or place any body part under the planter while lifting.
Keep all bystanders away. Do not remove shipping stands until
tongue is installed and parking jack is lowered.
!
WARNING!
Lifting hazard. The weight of the planter could bend the forks or
cause the forklift to tip over, which may lead to serious injury or
death. Consider strength of the forks, the planter center of grav-
ity and forklift balance. The forklift must be heavy enough to
carry the load.
!
WARNING!
Obey all safety instructions from lifting equipment manufactur-
er. Be sure shipping stands are securely attached prior to lifting.
Be sure lifting equipment has enough capacity to lift planter.
1. Attach lifting chain to planter frame and forklift. Lift
frame and stands. With stands off the ground, back up
forklift. Chain should become taut.
15060