Great Plains TSF1290 Predelivery Manual - Manual (Page 16)

14 TSF1080, TSF1090, TSF1280 and TSF1290
500-641Q 11/08/2006
Tractor / PTO Shaft Hook-Up
DANGER
!
Rotating drive-line contact can cause death. KEEP AWAY!
Do not operate without guards attached and drive-line
securely attached at both ends.
Refer to Figure 10 and Figure 11
1. The tractor drawbar should be adjusted to ASAE
standard or as shown. Adjust implement drive-line
to a position which is level with the tractor PTO
2. Position PTO shaft on tractor. Be sure shaft is cou-
pled on tractor.
Refer to Figure 12
3. Adjust the vertical position of the pump drive shaft
on the sprayer so that it is level, to slightly higher
than level with the PTO shaft on the tractor as
shown. This reduces drive-line vibration when
turning a corner. Adjust the vertical position by
moving the four bolts supporting the drive shaft
bracket.
IMPORTANT !
If, after adjusting the vertical position of the pump
drive shaft, the drive shaft is still a lot higher than the
PTO drive shaft on the tractor; adjust the hitch up
one position and readjust the pump drive shaft. Refer
to Hitching Tractor to Sprayer in this section starting
on page 10 to adjust the hitch.
Figure 10
Tractor Drawbar Adjustment
(540 rpm only)
15764
Figure 11
Tractor Drawbar Adjustment
(1000 rpm only)
15765
Figure 12
Hitch Height Adjustment
15837