Great Plains TSF1290 Predelivery Manual - Manual (Page 9)

Assembly 7
11/08/2006 500-641Q
Assembly
The following headings are step-by-step instructions for
assembling the Trailer Sprayer. Begin with Tools
Required and Pre-Assembly Checklist to make sure you
have all necessary parts and equipment. Then proceed
with Unload Boom from Truck. Follow each step in order
to make the job as quick and safe as possible and pro-
duce a properly working machine.
The Trailer Sprayer is shipped via flat bed truck. It is the
dealer’s responsibility to unload the boom. Unload all
equipment before beginning assembly. Do not attempt
any assembly work with the Trailer Sprayer on the truck.
Tools Required
• General hand tools
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of
obstructions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with boom.
IMPORTANT !
If a pre-assembled part or fastener is temporarily
removed, remember where it goes. Keep the parts
separated.
6. Have a copy of the parts manual on hand. If unsure
of proper placement or use of any part or fastener,
refer to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
8. Check that all safety labels and reflectors are cor-
rectly located and legible. Replace if improperly
located or damaged. Refer to Safety Decals in the
section “Important Safety Information” in the
operator’s manual.
Unload Boom from Truck
9. Using a forklift or tractor, remove boom from truck.
Do not remove shipping stands until you are ready
to assemble boom.
10. When ready to assembly boom, place sprayer in
an open, level area. Make sure there is enough
overhead and side clearance to fold and unfold
assembled boom.
After Unloading
11. Remove shipping straps.
12. Remove yoke from hitch.
Remove Shipping Straps
Refer to Figure 1
13. On the 1250 gallon sprayer use strap cutters to cut
the metal straps and remove the wooden blocks
used to support the booms during shipping.
Figure 1
Shipping Strap
21882